adhesive power

Investigation on adhesive power of silicon film to glass substrate

玻璃基板上硅薄膜附着力的研究

On Line Detecting Adhesive Power of Electric Locomotives

电力机车粘着牵引力的在线检测

The glue has some technical characteristic such as great elongation, high elasticity, strong adhesive power with concrete, adjustable color, fitting surface-drying time, tolerably working on the condition of moist slot, and so on.

该嵌缝材料具有伸长率大、弹性高、与混凝土粘接力强、色彩可调、表干时间适宜，并可在缝内潮湿情况下施工等技术特点。

Adhesive power, peeling strength, chromatic aberration, impact strength retention rate and other indicators can be more comprehensive characterization of color profiles of weathering resistance.

附着力、剥离强度、色差、冲击强度保留率等指标能比较全面的表征彩色型材的耐候性能。

Density surface tension wettability and adhesive power of liquid Al and Al-RE Alloy on BN surface

液态Al和Al-RE合金的密度、表面张力及对BN的润湿性和附着功

S: The use of MQ silicone resin as reinforcing material for additive type liquid silicone rubber ( LTV) could endow the LTV with better mechanical properties and fluidity. It has better adhesive power for metals, glasses and ceramics.

MQ树脂用作加成型液体硅橡胶（LTV）的补强材料，可赋予LTV较好的机械性能、很好的流动性，对玻璃、陶瓷等材料较好的粘接性；

Test method for electric strength of insulating adhesive tape at power frequency

GB/T7752-1987绝缘胶粘带工频击穿强度试验方法

The check of the belt strength and strain is bosed upon that tension and strain. Test method for electric strength of insulating adhesive tape at power frequency

胶带强度和应变的校核均应以该处胶带断面的张力和应变为依据。GB/T7752-1987绝缘胶粘带工频击穿强度试验方法

Conclusion EDTA with density 10% is more effective in both the rinse of smear layer of root canal and the enhancement of adhesive power of casting post.

结论浓度为10%的EDTA在去除根管内玷污层，提高桩冠固位力方面效果最好。

The coating has high strength, strong adhesive power and good wear resistance.

涂层硬度高，附着力强，耐磨性好。

This paper dealt with the methods for increasing the properties of glass fiber reinforced PP ( GFRPP) and the adhesive power of glass fiber and PP.

探讨了提高玻纤增强聚丙烯性能、提高玻纤与聚丙烯结合力的方法。

Development of Zn/ Al_2O_3 and Zn/ SiO2 Combined Platings and Study of Their Corrosion Resistance and Adhesive Power

Zn/Al2O3和Zn/SiO2复合镀层的研制及其耐腐蚀性和结合力的研究

The hook covered with this adhesive has better holding power as compared with the market products.

所得产品与市场同类产品相比,具有较高的持粘力.

The performances of three kinds of gels were compared by the experiments of viscosity, gel intensity, syneresis rate, adhesive power, gel freezing point as well as melting point and so on.

进行黏度、凝胶强度、凝胶水析率、凝胶黏着力、凝胶凝固点及熔点测定等试验，以对比几种凝胶的性能。

Aluminum film is produced on glass, H13 steel, plastic and pure Cu substrate by resistance heating vacuum evaporation, and the adhesive power of aluminum film is determined and analyzed.

采用电阻加热式真空蒸镀法在玻璃、H13钢、塑料和纯铜基体上镀制铝膜，并对其附着力进行了测试和分析。

This observation led to the presumption of a struc-tural model of the electrode and explained the beneficial effects of the intermediate layer on depressing the interfacial resistance of the electrode and improving the adhesive power between both β-PbO_2/ SnO_2 and Ti/ SnO_2.

因而提出了电极结构模型的假设，并且解释了中间层对降低界面电阻，改进β&PbO2/SnO2与Ti/SnO2之间结合强度的有益作用。

Lacquer sheathing sprayer can spray evenly lacpuer on the road . to improve adhesive power.

该机的作用是降低其均匀喷涂到地面, 增强涂料与地面间的附着力.

If ink cannot be completely cured, they will receive the adhesive power weakened.

如果油墨不克不及合座固化, 它们的附着力必然会收到巩固.

The obtained stainless steel colored film is bright and beautiful, assuming the golden color, which has excellent corrosion resistance, wear resistance and good adhesive power.

所得到的不锈钢着色膜光亮美观，呈金黄色，具有优良的耐蚀性、耐磨性和良好的附着力。

Rich zinc phosphatization : enhance the adhesive power of coating and base materials.

富锌磷化: 增强涂膜与基材的附着力.

EP/ PU function graded coatings not only had the strong adhesive power like EP, but also had the excellent corrosion resistant property like PU: the adhesive power achieved the first level, and resistance to impact 65kg · cm, and coefficient of attrition rate 0.042.

环氧/聚氨酯梯度涂层兼有环氧树脂与基体结合紧密的优点和聚氨酯良好的耐冲蚀磨损性能：附着力达到了1级；耐冲击性达到65kg·cm、磨损率为0.042。

A comprehensive research was conducting on the relations among its solidified behavior, vitrification point, adhesive power, impact strength and peel strength.

研究了导电涂层固化行为与玻璃化温度、附着力、冲击强度和剥离强度之间的关系，确立了导电涂料的最佳固化条件。

The composition and syntheses of a newly developed specific binding agent for cellulated paperboard and the influence of components of binding agent on adhesive power and drying speed are presented.

对蜂窝纸板专用粘合剂在合成路线，工艺配方等方面进行了讨论，并对该种粘合剂的组分对其在粘度和干燥速度等方面的影响进行了分析。

Study on the Adhesive Power of Aluminum Film on Different Substrate Prepared by Vacuum Evaporation

不同基体真空蒸镀铝膜的附着力研究

The 3rd-generation MSCs were cultured combining with PLGA-ASP-PEG in vitro, while cells cultured in PLGA as control group. The cell adhesion rate and the adhesive power were examined by conventional precipitation method and micropipette aspiration technique respectively.

将第3代MSCs以1.0×106/ml接种到PLGA-ASP-PEG材料上，测定细胞黏附力和黏附率；

II: good adhesive power to metal, plastics, glass wood, etc.

对金属 、 塑料 、 玻璃、木材等有较好粘结力.

Traditional methods of producing catalyst coating have disadvantages of complex technology and higher cost, and the coating granules are easily broken off owing to weak adhesive power and then block the reactive channel.

传统的催化剂涂层制备方法工艺复杂、成本较高，存在涂层附着力不强、容易脱落及堵塞通道等问题。

Wheel rail adhesive power is an important variable deciding tractive performance of electric locomotives, but it is not a directly detectable variable.

轮轨粘着牵引力是决定电力机车牵引性能的重要参量，但不能被直接检测到。

After annealing at 50~ 350 ℃, the adhesive power of aluminum film on pure Cu substrate is higher than that before annealing, and increases with the increase of annealing temperature. Within the layer the copper?

在50~350℃之间退火后，铝膜对纯铜基体的附着力高于退火前，且随退火温度的升高而增大。

And designs the flexible relief block printing ink characteristic of good flexibility, strong adhesive power, well-antifreezing and low cost.

设计出具有柔性好、附着力强、抗冻性好，且成本低的柔性凸版油墨。